A machined case half in four easy steps….

That is the goal, anyways. We are diligently working to machine each case half in FOUR operations. Two on the one side, two on the other side. You’re probably askingĀ  – what about the ends?

Well, we have adapted our machining model such that it works on a 5 axis machine, therefore there are only four “setups” or operations. The ends get taken care of during one of the four operations.

As usual, tons of handwritten notes and measurements. To say this is a complicated job is an understatement, but we are getting there.

Leave a Reply

Your email address will not be published. Required fields are marked *