Although scanning the case was a monumental and expensive effort, in and of itself, a Solidworks drawing of a case is pretty much useless for building the tooling needed to actually build a case.

But it’s a start.

This is where the toolmaker comes in. In order to cast new cases, you need to build tooling. Mainly, this is where the bulk of the expense lies in this little project.

Also, and super importantly, the case doesn’t pop out of the mold looking like one that’s in your car. Here are the differences:

  • The raw casting needs to have machining meat on the mating halves, the mains, and just about every surface that will be machined in any way, shape or form. That means that our casting will be thicker in many places than the actual finished case, since it will be machined down later.
  • We need to add draft to our drawing so that the case can be pulled from the mold properly.
  • Our case is sand cast; the original Porsche┬« case was die cast. Die casting is a little different than sand casting, so our mold is markedly different from a die cast mold.

In short, the Solidworks drawing needs to be worked over by a team of tooling and pattern makers into something that can be used to make a mold. Which is very, very expensive!


Pin It on Pinterest

Share This